Clearaudio UF1 (ULTRA FILTER) - Manual (Page 5)

Ultra Filter UF1
User manual
Page 5
 clearaudio electronic GmbH 2010
Important:
Before you connect the Ultra Filter UF1 to the power outlet, please be sure, that
the input voltage of the equipment is suitable to the voltage of the mains supply.
1. Place the
UF1 Filter preferably close to your HIFI – system.
2. Please pay attention that equipment (e.g. Phono-Preamplifier, turntable or tape recorder)
which are sensitive to electromagnetic forces are not too close placed to the
UF1 Filter .
3. To avoid signal disturbances don’t direct A.F signalling cable too close to the
UF1 Filter .
4. Connect the main cable to the
UF1 Filter and switch the UF1 Filter on (button “3” on the
backside).
5. The
Ultra Filter UF1 identify the polarity of the mains plug automatically.
If you hear a whistling sound after you switched on the Ultra Filter, please switch the UF1 off
and turn the mains plug to 180°.
6. After the main switch is pressed the
Ultra Filter UF1 is in normal operation and the power
sockets are supplied with power.
7. You can see the current output voltage on the front digital display (Page 3 / No. 2 / Pic. 1).
8. With the button on the front side of the
Ultra Filter UF1 (1) (see Page 3 / No. 2 / Pic. 1) you
can changed from the normal operation to the standby operation.
In the standby – modus all power sockets are not supplied with power and the light of the
digital display is getting out.
Important:
If you switch off the complete HiFi – systems output interferences can occur and
damage your loudspeakers.
To avoid this, please first switch off your power amplifier before you switch off the
other equipments.