Brocade Communications Systems Brocade Network OS 2.1 - Manual (Page 39)

Network OS Documentation Update 29
53-1002606-06
Chapter
4
Brocade VDX 6710-54 Hardware Reference Manual
In this chapter
The updates in this chapter are for the Brocade VDX 6710-54 Hardware Reference Manual, part
number: 53-10002390-04, published March 2012.
• Chapter 4, Brocade VDX 6710-54 Operation . . . . . . . . . . . . . . . . . . . . . . . . 29
• Chapter 5, FRU Removal and Replacement Procedures . . . . . . . . . . . . . . . 29
Chapter 4, Brocade VDX 6710-54 Operation
Under the heading “Brocade VDX 6710-54 management” on page 29, replace Table 5 with the
following information.
TABLE 5 Management options for the Brocade VDX 6710-54
Chapter 5, FRU Removal and Replacement Procedures
Under the heading “Replacing the power supply and fan assembly” on page 36, add a step after
step 5 and before the paragraph that says “"You can display the power supply and fan assembly
status using the following commands from the CLI:”
Step 6. If you have changed the airflow direction in the chassis by installing two FRUs with a new
airflow direction, you must run the command chassis fan airflow-direction
[port-side-direction], where the [port-side-direction] operands are either port-side-intake or
port-side-exhaust, depending on which direction the airflow is directed.
switch# chassis fan airflow-direction port-side-exhaust
Previous configuration : port-side-intake
Current configuration : port-side-exhaust
System fan airflow-direction changes will be effective after reboot!!
Management tool Out-of-band support In-band support
Command line interface (CLI)
Up to two admin sessions and four user sessions simultaneously.
For more information, refer to the Network OS Administrator’s
Guide and the Brocade Network OS Command Reference. Ethernet or serial
(console port)
connection In standalone mode
only. Not available in
VCS mode.
Standard SNMP applications
For information, refer to the Network OS Administrator’s Guide
and the Brocade Network OS MIB Reference. Ethernet or serial
(console port)
connection N/A
Brocade Network Advisor
For information, refer to the Brocade Network Advisor SAN+IP
User Manual. Ethernet (preferred)
or serial (console
port) connection N/A