Ovation, Service – Clearaudio OVATION User Manual
Page 11
Ovation
User manual
Page 11
Clearaudio electronic GmbH 2014
Please note:
If the turntable does not reach the correct speed, the sensor or the scale ring could be dirty or
dusty.
To clean the sensor, please take off the two platters very carefully!
Clean the sensor and the scale ring with a little isopropyl alcohol and a cotton bud.
Be careful to avoid scratching the sensor or the scale ring!
If the motor has further speed issues please contact your nearest authorized Clearaudio dealer or
directly the Clearaudio factory.
Now you are finally ready to play your vinyl records!
Attention:
If the turntable is not in use, disconnect the unit completely from the power supply by removing the
main plug from the socket.
We wish you a lot of pleasure with your new
Ovation
- turntable.
3. Service
If any service or repair on all Clearaudio products is necessary, please contact your dealer /
distributor or contact Clearaudio directly. We can inform you about your nearest service location.
Transportation advice:
If any transportation of the
Ovation
-turntable should be necessary, please always remove the
turntable platter. Otherwise serious damage can occur!
The bearing hole needs to be covered as well, to avoid any dust coming into the bearing. Always
take of the pulley of the motor unit as well, to prevent the motor shaft from any damages.
PLEASE RETAIN ALL ORIGINAL PACKAGING. You will need it if this unit has to be transported
and/or shipped. Any further questions you may have about this turntable should be directed to the
distributor or directly to Clearaudio at
Clearaudio electronic GmbH
Spardorfer Str. 150
91054 Erlangen
Germany
Tel/Phone: +49 9131 40300100
www.analogshop.de