Calculated Industries 6250 - Manual (Page 22)

1
2
MEASURING POLYLINES
OPERATING SEQUENCE
1. Press the [ON/CLEAR] key twice to clear the display.
Place the crosshairs over the fi rst point and press the
[MEASURE]
key.
2. Move to the second point and press the [MEASURE] key.
The display will show the Length of the 1st line segment.
3. Move to the third point and press the [MEASURE]
key. The display will show the accumulated Length
of the two measured segments.
PERIMETER
4. Press the [END] key. The
total Perimeter is displayed.
U
SER’S
G
UIDE
— 19
ILLEGAL SHAPE:
The Area can not be calculated for a
shape containing bisecting lines. The
Area of the shapes resulting from
the bisecting lines can be calculated
individually.
1
2
3
4
3 4