Calculated Industries 6020 v3.2 - Manual (Page 4)

2 – Scale Master
®
Classic
[MODE] – Mode Selection
Used to toggle between the following scale
modes (in sequence):
1) Architectural (
ARCH )
2) Engineering I ( EnG I )
3) Engineering II ( EnG II )
4) Custom ( CUSTOM )
5) Count ( COUnT )
[SUBTRACT/COUnT]+[MODE] –
Unit Selection
Holding [SUBTRACT/COUnT] and
repeated presses of [MODE] will scroll
through the available units. Values can be
converted from U.S. units to Metric within
the U.S. mode. However, values cannot
be converted from Metric to U.S. when in
Metric mode.
[SCALE] – Scale Selection
Used to toggle between various scales within
each scale mode. See “Built-In Scales” section.
[M1+] – Memory Add key (Length)
Adds the displayed value to the M1+
memory. This key is used to store a length in
order to calculate an area.
[M2x] – Memory Add key (Width)
Adds the displayed value to the M2x memory.
This key is used to store a width in order to
calculate an area. When a length and width have
been stored in [M1+] and [M2x] , pressing
[RCL] [M2x] displays the stored width, the
next press of [M2x] displays the area calculated
from the stored length and width, and the next
press of [M2x] displays the calculated volume if
a height has been stored. Please see page 12 for
calculating an Area and Volume.