Bryant Commercial TSTATBBPCM01-A - Manual (Page 2)

This is more efficient than making the system run at full ca-
pacity until the desired temperature is met.
NOTE: Smart Recovery does not apply to cooling operation.
III. SET CURRENT DAY
The Change Day button will change the day shown on the
thermostat display to the next day. If a schedule has been
entered, the thermostat will follow the schedule of the new
selected day.
IV. SET CURRENT TIME
The Set Time button allows the user to change the time dis-
played on the thermostat. Press the Set Time button. The dis-
play will show the SET TIME annunciator. Press the Up and
Down buttons until the correct time is shown. Hold down the
buttons to quickly move through the time display. The AM
and PM annunciators will automatically change. To ensure
the schedules are properly followed, make sure that AM or
PM is correct for the time chosen. When the correct time is
shown, press the Set Time button again to exit the Set Time
mode.
V. RESET FILTER
The Reset Filter button is used to clear the ЉClean FilterЉ icon
on the display screen. The ЉClean FilterЉ icon reminds the
user when it is time to change or clean the filter of the unit.
VI. PROGRAMMING THERMOSTAT SCHEDULES
Before programming the thermostat, plan the thermostat daily
schedule. The schedule is divided into 7 days (Monday through
Sunday). Each day has 4 time periods (OC1, UN1, OC2, UN2).
Each time period has a start time, heating set point, and cool-
ing set point. Fill in Table 1 on page 3 as an aid to program-
ming the daily schedules.
A. Programming Mode
To program the daily schedules, perform the following
procedure:
1. Enter programming mode by pressing the Program but-
ton. The PROGRAMMING annunciator will appear on
the thermostat display. The first day of the schedule
(MON) will be displayed and the first programming time
period (OC1) of that day will be displayed. The SET TIME
annunciator is also displayed.
NOTE: If a programming button is not pushed for 60 sec-
onds, the thermostat will exit programming mode and any
changes made will be saved.
2. Press the Up and Down buttons to set the start time for
the schedule day and period shown (MON, OC1).
3. Press the Program button once the correct time is shown.
The SET TIME annunciator will turn off and the SET
DESIRED TEMP annunciator will be displayed.
4. The heating and cooling set points can now be pro-
grammed. The HEAT and COOL annunciators are dis-
played for the heating and cooling set points respectively.
The mode button is used to toggle between the heating
and cooling set points. Use the Up and Down buttons to
raise and lower the temperature set points.
NOTE: There must be at least 3 degrees difference between
the cooling and heating set points. The thermostat will au-
tomatically change any set points closer than 3 degrees.
5. Press the Program button to advance to the next time
period (UN1).
LCD
DISPLAY
SCREEN
UP
BUTTON
DOWN
BUTTON
Fig. 1 — Thermostat Display and Programming Buttons
—2—