Calculated Industries QFCCL - Manual (Page 42)

P
OCKET
R
EFERENCE
G
UIDE
— 38
APPENDIX A – DEFAULT SETTINGS
After a Clear All ( c x ), your calculator
will return to the following settings:
STORED VALUES US MODE METRIC MODE
Seam Width 1/4 Inch .635 cm
Fabric Width 40 Inches 101.6 cm
Binding Cut 2-1/2 Inches 6.35 cm
Width
Backing
4 Inches 10.16 cm
Overage (+)
Note: The default values for Metric are
equivalent to the US mode default values,
but you may store any value for each of
these items.
After a Full Reset (press F , hold down
x , and press N ), your calculator will
return to the following settings (including
those listed above for Clear All):
PREFERENCE SETTINGS DEFAULT VALUE
Corner (Miter vs. Straight) Mitered Corners
Sashing
Include Sashing Border
US/Metric Mode US/Fractional Value
Reset Function
If your calculator should ever “lock up,”
press Reset—a small hole located just
below the
F key—to perform a total reset.
Reset