Calculated Industries 9430 - Manual (Page 23)

22 — ScheduleCalc ™
Multiplication
Period x Period = Error
Point x Period = Error
Point x Point = Error
Period x Number = Period
Point x Number = Error
Division
Period ÷ Period = Number
Period ÷ Number = Period
Period ÷ Point = Error
Point ÷ Period = Error
Point ÷ Number = Error
Point ÷ Point = Error
Time Values
If the “ SECS ” preference setting is
“ On ”, the display shows a place holder
(00) for seconds even if the ß key
was not used.
If set to “ OFF ”, you must press the ß
key to display the seconds placeholder.
If entering points in time, it is not
necessary to use the
: key. See
Method 5 for an alternate method.
When entering time values, you may
use any of the following entry methods.
However, remember to always enter
Hours first, then Minutes, then
Seconds.
(Cont’d)