Calculated Industries 4095-A Pocket Reference Guide - Manual (Page 15)


mATh chAIn

(Repeats options) mATh ordEr
enTerinG dimensions
linear Dimensions
When entering feet-inch values, enter dimen-
sions from largest to smallest — feet before
inches, inches before fractions. Enter fractions
by entering the numerator (top number),
pressing  (Fraction Bar key) and then the
denominator (bottom number).
Note: If a denominator is not entered, the
fractional setting value is used.
Examples of how linear dimensions are
entered (press  after each entry):
DImENSIoNS KEySTRoKES
5 feet


5 feet, 1 ½ inches

     
17.5 meters

7   
1250 millimeters

    
Square and cubic Dimensions
Examples of how square and cubic dimensions
are entered (press  after each entry):
DImENSIoNS KEySTRoKES
14 square inches    
11 square feet    
P
ocket
R
efeRence
G
uide
— 17
4095 Inside_Corrected.indd 15 4/27/2009 8:42:57 AM