Calculated Industries 4215 User Manual

Page 12

“Desired Riser Height”. Undimensioned
values are assumed to be inches.

[Circ]

Circle — Based on an entered diameter,
repeated presses display the following cir-
cular values: 1) diameter, 2) area 3) cir-
cumference.

[Conv] [Circ]

Arc Length — Used to find the arc length
based on an entered diameter and angle.
For example:

1 [Inch] [Circ] 180 [Conv]

[Circ] would display an Arc length of 1-
9/16 inches for an entered diameter of 1
inch and a 180° angle.

Fractional Rounding Settings

[Conv] 1

Fraction set to 1/16

[Conv] 2

Fraction set to 1/2

[Conv] 3

Fraction set to 1/32

[Conv] 4

Fraction set to 1/4

[Conv] 6

Fraction set to 1/64

[Conv] 8

Fraction set to 1/8

12 – ConcreteCalc™