Calculated Industries 4225-B - Manual (Page 9)

P
OCKET
R
EFERENCE
G
UIDE
— 6
T B Block Size — Stores the
block size. Block size must
be entered as a linear value
or a square value. The
default is 128 square Inches
block Area and 16 Inches
block Length.
Note: For bricks, you may also enter a brick size
using
T B . For example, when building
with standard “face” bricks, store a brick size of
21 square Inches (e.g.,
2 1 i i T
B ) or store 32 square Inches (e.g., 3 2 i
i T B ) for “paver” bricks. This is based
on Modular U.S. brick size of 3-5/8 Inches x 2-
1/4 Inches x 7-5/8 Inches, including 3/8 Inch
mortar = 4 Inches x 2-5/8 Inches x 8 Inches.
ß Square-Up Key —
Calculates the “Square-Up”
(diagonal) Length given
entered Length and Width
values.
d Drop Key — Calculates
total drop (or fall) over an
entered Length given,
entered percentage drop,
Inch per Foot drop, or
degrees of drop. Continued
presses will act as a “con-
stant add,” for displaying
successive drops.
Ç 8 Board Feet — Enters or
converts cubic values to
board Feet.
З з Column/Cone — Calculates
the Volume and surface Area
of a column and/or cone.