Brother, Brother & Sons BBS Software ver. 1.0.0.0 User Manual
Page 5
Uploading new software to your BBS fixture
1. Make sure the fixture is NOT powered on.
2. Connect the Uploader to a USB port and check that the power LED is on and that the 4 LEDs
are running their chase.
3. Connect the fixture to the Uploader with a DMX 512 cable from the Uploader’s
DMX OUT to the fixtures DMX IN.
4. Turn the fixture on.
5. The fixtures display will read “SYnC”
6. As upload starts the display show a count from “P1”, “P2”, “P3” up.
7. When the fixture has successfully received the new software, the display will
show the DMX address again.
8. Disconnect the dmx cable and turn the fixture off.
9. Turn the fixture back on and check the display for the correct software version.
Page 4