Brinno BWC - Manual (Page 4)

How to set up your Brinno BirdWatchCam
(Read WARNING LABEL
on BirdWatchCam before
using.) Mounting hole
Mounting Unit
Friction Lock
Door Latch
Suction cup
Laser Pointer
Optical lens
Motion Sensor
Power Button
Remove the BirdWatchCam from the package.
Check to make sure that all the contents are
included.
Open up the BirdWatchCam by gripping the back of
the camera in one hand and lifting up firmly on the
door latch where it says “PULL”.
Insert the 4 AA batteries included in the package
following the polarity markings ( + - ) inside the
camera.
Insert SD card into the BirdWatchCam (2GB SD
card included in package).
***(Please note that the maximum size SD card
supported by the BirdWatchCam is a 8GB SD
Card. If you use a SD card with a larger memory
density the camera will not function properly.
Close the BirdWatchCam.
The mounting unit attaches to the camera by
gripping the front of the camera firmly with one hand
and sliding the mounting unit into the back of the
camera. On the side of the unit that locks directly into
the camera please note that there is an arrow that
shows the top of the mounting unit. Be sure to insert
it so the arrow is facing up. (See images on page 3)
Once the mounting unit is locked firmly into the
camera you are ready to begin the mounting process.
The three pre-set distances, 1.5 Meters, 2 Meters and
3 Meters are clearly marked on the measuring tape
included in the package.
When setting up your BirdWatchCam, consider the
camera in relation to the sun. You will get better
images if the BirdWatchCam is in between the sun
and the targeted area, and not facing into the sun
directly.
Once you have decided on the mounting distance
from your bird feeder, use the measuring tape to
locate your BirdWatchCam correctly
4.
1.
2.
3.
5.
6.
7.
8.
9.
10.
11.
-02