Bonide Wilt Stop Plant Protector RTU - Manual (Page 2)

INSTRUCTIONS
SHAKE WELL BEFORE USING. SPRAY TOPS AND BOTTOMS OF
LEAVES, NEEDLES AND STEMS TO RUN-OFF. ALWAYS ALLOW WILT
STOP® TO DRY OUTDOORS IN DAYLIGHT, WASH SPRAYER WITH
WARM WATER AND DETERGENT AFTER EACH USE.
READ ENTIRE LABEL PRIOR TO USE!
Excessive moisture loss from plants causes severe wilting, shock or plant
death. It occurs in winter when drying winds and frozen ground deprive
plants of their natural moisture intake, when plant roots are disturbed
during transplanting, during periods of drought, or when Christmas trees
and greens are cut. WILT STOP® forms a protective coating which holds
moisture in on plant foliage reducing water loss during plant stress. WILT
STOP® forms a clear flexible film without interfering with plant growth. Only
one application per season is typically needed.
WILT STOP® can be used on deciduous trees, evergreens, shrubs, turf,
roses, flowering plants, vegetables, fruits, transplants, cut plants, indoor
plants, Christmas trees, and others.
For spring, summer and fall transplanting, water plants thoroughly, when
possible, before spraying with WILT STOP®. Do not spray or dip roots.
TRANSPLANTING
FOR DROUGHT AND WINDBURN PROTECTION
Spray once each season, in the spring.