Bonide Stump Out Stump and Vine Killer - Manual (Page 2)

DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner
inconsistent with its labeling.
GENERAL INFORMATION
This product provides control of undesirable woody vines,
plants, and broadleaf weeds around homes, cabins, fences,
walkways, and other non-crop areas.
APPLICATION INSTRUCTIONS
To apply as a Stump Treatment: Apply this product undiluted
to kill stumps and prevent sprouting. Using the applicator top,
completely cover the freshly cut surface.
To use for Vine Control: For best results when treating vines
such as poison oak, poison ivy, etc. that grow on or around
desirable plants, cut the vine first and treat as directed above
for stump treatment. Do not let product contact desirable plants.
To apply as a Foliar Spray: In a hose-end or tank sprayer,
mix 8 to 16 tablespoons (4 to 8 fl. oz.) in enough water to
make one gallon of spray mixture. Apply at the rate of one
gallon spray mixture per 500 sq. ft. Coverage will depend
on the amount of foliage to be treated. Apply as a thorough
foliage spray to wet all leaves using a coarse spray pattern
with low pressure.
Use the higher rate for mature or hard-to-control plants (such
as ash, blackgum, choke cherry, elm, maple, oak, pine,
or winged elm), or during drought conditions. Using low
rates may result in resprouting of weeds in a year following
treatment.
Make applications when brush and weeds are actively grow-
ing with full leaf coverage. In 1 to 6 weeks, symptoms such
as wilting will occur. Make applications when the air is calm.
Effectiveness may be reduced if rainfall occurs with 24 hours
of application.