Bonide Burn Out Weed & Grass Killer Conc. - Manual (Page 2)

SHAKE WELL BEFORE USING.
This product is a contact, non-selective, broad spectrum, foliar applied
weed killer. It will only control actively growing emerged green vegetation.
It is effective on annual, perennial and grassy weeds. This product does
not translocate and will affect only those plants that are covered with the
spray solution. Use along borders, on driveways, sidewalks, around mature
tree bases, around buildings, along fence lines, around barns & pastures,
in greenhouses, school grounds, flower beds and other areas where weed
control is desired.
Mix 1 part of this product to 3 parts water (8 fl. ounces of this product in
24 fl. ounces of water OR 32 fl. ounces of this product in 96 fl. ounces of
water). Spray to the point of run-off, making sure that all of the foliage is
wet. One gallon of finished spray solution covers approximately 1,500 sq.ft.
Repeat application may be necessary if new growth appears. For larger
annuals and burndown of perennial weeds, higher application rates may be
required. To achieve higher application rates, mix 1 part of this product with
2 parts water. (8 fl. ounces of this product in 16 fl. ounces of water). Apply
spray solution to vegetation using equipment such as a trigger, hand-held,
back-pack, or tractor-mounted sprayer.
DIRECTIONS FOR USE
READ THE LABEL FOR APPLICATION INSTRUCTIONS AND
PRECAUTIONS PRIOR TO USE.
This product is exempt from registration with the Federal EPA under section
25(b) of FIFRA, and as such, is not registered with the Environmental
Protection Agency. Bonide represents that the ingredients qualify for
exemption from registration under FIFRA.