BLUESHAPE BSCVMon v2.0 - Manual (Page 4)

OS: Windows 2000/ XP/ Vista/ 7/ 8 either 32bit and 64bit (the drivers for the USB interface may not work properly
under older OS such as ME, 98, 95)
Minimum configuration: Pentium 3 or higher, 128Mb RAM or greater, 23MB HD disk space
A USB 1.0 port or greater per charger, or a USB hub
A BSCVMon USB cable per charger
Connection
Cable connection first !
During software installation, the special drivers for the USB cable are made available in the system.
Upon connecting the USB cable for the first time (no matter if the charger is connected or not), the cable is detected and
the driver is installed.
See the typical pop-up during the 'Found new hardware' wizard: (below)
Please note the BSCVMon can run only after a successful initial installation of the cable drivers.
Charger connection
Chargers can be connected and switched on even after BSCVMon starts.
Created with the Standard Edition of HelpNDoc: Easily create CHM Help documents