Blizzard Lighting TOURnado IP Beam - Manual (Page 12)

Page 12
TOURnado™ IP Beam User Manual Rev. A © Copyright 2014 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
Set the Starting DMX Address:
The default mode for the fixture is DMX, so the first menu item that you can edit is the
starting DMX address.
1.) Navigate the menu using the buttons until you reach Addr.
2.) Push the button.
3.) Use the buttons to select a DMX channel from 001-512.
4.) Press the button to confirm.
Select the DMX Channel Mode:
1.) Navigate the menu using the buttons until you reach CHnd.
2.) Push the button.
3.) Use the buttons to select either 6CH, 9CH, or 11CH mode.
4.) Press the button to confirm.
Slave Mode:
To synchronize one or more fixtures to follow the actions of the Master fixture (the 1st unit in
the DMX chain), perform the following steps on each Slave fixture:
1.) Set the DMX address to A001.
2.) Navigate the menu using the button until you reach SLAU.
3.) Push the button.
4.) Use the buttons to select SLAu.
5.) Press the button to confirm.
Auto, Stand-Alone, & Built-in Program Modes:
Allows a single or Master/Slaved units to run factory installed programs at user selectable speeds.
Auto Mode:
1.) Navigate the menu using the button until you reach ASC-.
2.) Push the button.
3.) Use the buttons to select from AC00-AC15.
4.) Press the button to confirm.
Standalone (Program) Mode:
Allows a single unit to display a variety of colors and programs without a DMX controller.
1.) Navigate the menu using the button until you reach Pr--.
2.) Push the button.
3.) Use the buttons to select from Pr00-Pr15.
4.) Press the button to confirm.
Flash/Fade Modes:
1.) Navigate the menu using the buttons until you reach FLAS or FAdE.
2.) Push the button.
3.) Now, you can adjust the flash rate from FL00-FL15 or the fade speed from FA00-FA15
with the buttons. Press the button to confirm.
Built-in Program Speed:
1.) Navigate the menu using the button until you reach SP-.
2.) Push the button.
3.) Use the buttons to select from SP00-SP15.
4.) Press the button to confirm.
Manual Color Adjustment:
1.) Navigate the menu using the button until you reach either rL-- (Red
Level), GL-- (Green Level), bL-- (Blue Level) or UL-- (White Level), then hit .
2.) Using the buttons, select the maximum level for each color between
x000-x255 (000=off), then hit to confirm.