Page 12, A001, Addr – Blizzard Lighting RGBAW ToughStick User Manual
Page 12: Flas or fade, Sp15, Sp00, Slav, Pr00- pr15
Page 12
ToughSTICK™ RGBAW Manual - Rev. B
Copyright (c) 2012 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the fi xture is DMX, which appears as
A001
on the LED Readout. To
select a different DMX address, using the button, select
Addr
,then hit
Use the
Stand-Alone, Master/Slave Modes:
Allows a single or Master/Slaved units to run factory installed programs at user selectable speeds.
1.) To set the fi xture in Flash/Fade mode, select
FLAS or FAdE
To confi rm, press the
2.) Now, select the fl ash or fade speed using button to reach
SP--
, then hit
The display reads
SP15
(slowest) to
SP00
(fastest), then press the
confi rm.
3.) To use the fi xture in automatic mode, select
ASC-
, then press the
confi rm.
4.) Adjust the speed of the chase as above using
SP15
(slowest) to
SP00
(fastest) then
press the
5.) To set the fi xture as a slave unit, select
SLAV
, and hit
then fl ash
SLAV
. Once it stops fl ashing, the fi xture is in slave mode.
Standalone (Program) Mode:
Allows a single unit to display a variety of colors and programs without a DMX controller.
1.) To set the fi xture in manual mode, select
Pr--
.
To confi rm, press the
2.) Now, select the program by using the
Pr00-
Pr15
. To confi rm, press the
Pr00 = Red
Pr01 = Green
Pr02 = Blue
Pr03 = Amber
Pr04 = White
Pr05 = R+G+B
Pr06 = W+A
Pr07 = Program #1
Pr08 = Program #2
Pr09 = Program #3
Pr10 = Program #4
Pr11 = Program #5
Pr12 = Program #6
Pr13 = Program #7
Pr14 = Program #8
Pr15 = Pr07-Pr14 Chase
Program Descriptions:
Program #1: 15-Color Chase, Full Bar
Program #2: Red + G/B/A/W Pixel Chase
Program #3: 5-Color Pixel Chase
Program #4: Red+Green + B/A/W Pixel Chase
Program #5: Red/Green/Blue Pixel Chase
Program #6: Blue/Amber/White Pixel Chase
Program #7: Inverse Color Pixel Chase
Program #8: R/G/B/A/W 3-Pixel Offset Chase