Blizzard Lighting EXA ToughStick - Manual (Page 3)

Page 3
ToughStick™ EXA User Manual Rev. A Copyright 2014 Blizzard Lighting, LLC
1. GETTING STARTED
What’s In The Box?
• 1 x ToughStick™ EXA
• 1 x Waterproof Power Cable
• 1 x Waterproof DMX Cable
• 2 x Mounting Brackets
• This Lovely User Manual
Optional Accessories (sold separately)
The following accessories are available for this fixture. But the lone wolves that they are, they
must be purchased separately. Contact your authorized Blizzard Lighting dealer for pricing!
• DMX-EXT: 3-Meter IP-Rated DMX Extension Cable
• PWR-EXT: 3-Meter IP-Rated Power Extension Cable
Getting It Out Of The Box
Yes way! Congratulations on your most excellent purchase and totally bodacious choice of one
stellar LED lighting fixture! So now that you’ve got your ToughStick™ EXA fixture (or hopefully,
ToughStick EXA’s!), you should carefully unpack the box and check the contents to ensure
that all parts are present and in good condition. If anything looks as if it has been damaged in
transit, notify the shipper immediately and keep the packing material for inspection. Again,
please save the carton and all packing materials. If a fixture must be returned to the factory, it
is important that the fixture be returned in the original factory box and packing.
Powering Up!
All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used
solely for a 0% to 100% switch.
AC Voltage Switch - Not all fixtures have a voltage select switch, so please verify that the fixture
you receive is suitable for your local power supply. See the label on the fixture or refer to the
fixture’s specifications chart for more information. A fixture’s listed current rating is its average
current draw under normal conditions. Check the fixture or device carefully to make sure that if
a voltage selection switch exists that it is set to the correct line voltage you will use.
Warning! Verify that the voltage select switch on your unit matches the line voltage
applied. Damage to your fixture may result if the line voltage applied does not match
the voltage indicated on the voltage selector switch. All fixtures must be connected to
circuits with a suitable Ground (Earthing).
Getting A Hold Of Us
If something is wrong, just give us a call or send an email. We’ll be happy to help,
honest.
Blizzard Lighting
N16 W23390 Stoneridge Dr. Suite E
Waukesha, WI 53188 USA
www.blizzardlighting.com
414-395-8365
Email: [email protected]
Disclaimer: The information and specifications contained in this document are subject to
change without notice. Blizzard Lighting™ assumes no responsibility or liability for any errors or
omissions that may appear in this user manual. Blizzard Lighting™ reserves the right to update
the existing document or to create a new document to correct any errors or omissions at any
time. You can download the latest version of this document from www.blizzardlighting.com.
Author: Date: Last Edited: Date:
J. Thomas 6/16/2014 J. Thomas 6/18/2014