Page 12 – Blizzard Lighting EXA ToughStick User Manual

Page 12

background image

Page 12

ToughStick™ EXA User Manual Rev. A

Copyright 2014 Blizzard Lighting, LLC

DMX Mode

Allows the unit to be controlled by any universal DMX controller.

Setting the Starting DMX Channel:

1.) The default mode for the fixture is DMX, which appears as d001 on the LED readout.

To select a different DMX address, using the

button, select Addr, then hit

. Use the buttons to select the correct address, then hit

TER> to confirm.

Setting the DMX Channel Mode:

1.) To select a DMX channel mode, press the

button, then use the or

buttons until the display reads Chnd and press the

button. Then

use the or buttons until the display reaches your desired channel

mode. Press the

button to confirm.

Stand-Alone, Master/Slave, Sound Active Modes:

Allows a single or Master/Slaved units to run factory installed programs at user selectable speeds.

1.) To set the fixture in Flash or Fade mode, select FLAS or FAdE. To confirm, press the

button.

2.) Now, you can adjust the flash settings from FL00-FL15 or the fade settings from

FA00-FA15. Then press the button to confirm.

3.) To use the fixture in automatic mode, select ASC-, and press the

button. Then use the buttons to choose from AS00-AS15. Now press

.

4.) Adjust the speed of the chase as above using SP15 (slowest) to SP00 (fastest) then

press the button to confirm.

5.) To set the fixture as a slave unit, select SLAU, and hit . The unit will

display a flashing SL.AU to indicate it is in slave mode.

Sound Active Mode:

1.) To use sound active mode, select SouA, then press the button to confirm.

Standalone (Program) Mode:

Allows a single unit to display a variety of colors and programs without a DMX controller.

1.) To set the fixture in manual mode, select Pr--. To confirm, press the

button.

2.) Select the program by using the and buttons to select Pr00-Pr15.

3.) To confirm, press the button.

Manual Color Adjustment:

Allows the user to adjust the color balance of the fixture. These settings are global, they will

effect all modes.

1.) Use the

and buttons to select either rL-- (Red Level), GL--

(Green Level), bL-- (Blue Level), AL-- (Amber Level), IL-- (White Level), or UL (UV

Level), then hit the button.

2.) Using the buttons, select the maximum level for each color between

x000-x255 (000=off), then hit to confirm.

See also other documents in the category Blizzard Lighting Lighting: