Page 13, Troubleshooting – Blizzard Lighting Switchblade (Rev A) User Manual
Page 13
Page 13
SwitchBlade™ Manual Rev. A
© 2014 Blizzard Lighting, LLC
Troubleshooting
Symptom
Solution
Fixture Auto-Shut
Off
Check the fan in the fi xture. If it is stopped or moving slower than
normal, the unit may have shut itself off due to high heat. This is to
protect the fi xture from overheating. Clear the fan of obstructions,
or return the unit for service.
Beam is Dim
Check optical system and clean excess dust/grime. Also ensure that
the 220V/110V switch is in the correct position, if applicable.
No Light Output
Check to ensure fi xture is operating under correct mode, IE sound
active/auto/DMX/Etc., if applicable.
Chase Speed Too
Fast/Slow
Check to ensure proper setup of speed adjustment.
No Power
Check fuse, AC cord and circuit for malfunction.
Blown Fuse
Check AC cord and circuit for damage, verify that moving parts are
not restricted and that unit’s ventilation is not obstructed
Slow Movement
Verify that 220V/110V switch is in the correct position, if applicable.
Also check that speed channels are set appropriately.
No Response to
Audio
Verify that the fi xture is in “Sound Active” mode.
Adjust Audio Sensitivity, If Applicable.
Fixture Not
Responding /
Responding Er-
raticly
Make sure all connectors are seated properly and securely.
Use Only DMX Cables and/or check cables for defects
Install a Terminator.
Reset fi xture(s).
Intermittent
Lamp
Check lamp for properly installation.
Relamp, lamp may have reached end of life.
Remote Doesn’t
Work
Verify remote control cable is installed properly and securely.
Verify remote is correct type (CA-9 or other as applicable.)
Fixture Moving
On Its Own
Verify proper mode of operation. Is the fi xture in “Auto” mode?
If your problem persists or isn’t listed contact [email protected].
If your problem isn’t listed, or if problems persist, please contact support: sup-