Blizzard Lighting FX SnowBlind (Rev B) - Manual (Page 13)

Page 13
SnowBlind™ FX Manual - Rev. B Copyright (c) 2013 Blizzard Lighting, LLC
DMX Values In-Depth (6-Channel Mode)
Ch. Value What It Does
1 000 <--> 255 LED 1 Intensity (0% <--> 100%)
2 000 <--> 255 LED 2 Intensity (0% <--> 100%)
3 000 <--> 255 LED 3 Intensity (0% <--> 100%)
4 000 <--> 255 LED 4 Intensity (0% <--> 100%)
5 000 <--> 255 Flash (Slow <--> Fast)
6
000 <--> 069
070 <--> 104
105 <--> 139
140 <--> 174
175 <--> 209
210 <--> 244
245 <--> 255
Static Color & Strobe
Program 1 (Channel 1 Controls Speed)
Program 2 (Channel 1 Controls Speed)
Program 3 (Channel 1 Controls Speed)
Program 4 (Channel 1 Controls Speed)
Sound Active Mode 1
Sound Active Mode 2
Troubleshooting
Symptom Solution
Fixture Auto-
Shut Off
Check the fan in the fixture. If it is stopped or moving slower
than normal, the unit may have shut itself off due to high
heat. This is to protect the fixture from overheating. Clear
the fan of obstructions, or return the unit for service.
Beam is Dim Check optical system and clean excess dust/grime. Also
ensure that the 220V/110V switch is in the correct position, if
applicable.
No Light Out-
put
Check to ensure fixture is operating under correct mode, IE
sound active/auto/DMX/Etc., if applicable.
Chase Speed
Too Fast/Slow
Check to ensure proper setup of speed adjustment.
No Power Check fuse, AC cord and circuit for malfunction.
Blown Fuse Check AC cord and circuit for damage, verify that moving parts
are not restricted and that unit’s ventilation is not obstructed
Slow Move-
ment
Verify that 220V/110V switch is in the correct position, if ap-
plicable. Also check that speed channels are set appropriately.
No Response
to Audio
Verify that the fixture is in “Sound Active” mode.
Adjust Audio Sensitivity, If Applicable.
Fixture Not
Responding /
Responding
Erraticly
Make sure all connectors are seated properly and securely.
Use Only DMX Cables and/or check cables for defects
Install a Terminator.
Reset fixture(s).
Intermittant
Lamp
Check lamp for properly installation.
Relamp, lamp may have reached end of life.