Blizzard Lighting SnowBank (Rev B) - Manual (Page 14)

Page 14
SnowBank User Manual Rev. B © 2012-13 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the fixture is DMX, which appears as
d001
on
the LED Readout. To select a different DMX address, hit the
button and use the buttons to select the correct address,
then hit again to confirm.
Auto, Master/Slave, Sound Active Modes:
Allows a single or Master/Slaved units to run factory installed programs at user
selectable speeds.
1.) To use the fixture in 7 channel or 26 channel mode, use the
d001
and hit the button. Continue to
push the button and scroll to either
7-CH or 26CH.
2.) To set the fixture in automatic mode, use the to scroll to
AU7O,
and hit . Then use the buttons to select
n001 - n100
and hit . From here you can now adjust the
chase speed by selecting from
SP01
(slowest) to
SPFL
(fastest).
3.) To set the fixture to run just one of its 22 built-in chase patterns, use
the to scroll to
Pr--,
and hit . Then use the
DOWN> buttons to select
Pr01 - Pr22
and hit . From here
you can now adjust the chase speed by selecting from
SP01
(slowest)
to
SPFL
(fastest).
4.) To use the fixture as either a slave unit, use the button to
scroll to
SLAu
and then hit the button. Your fixture will then
be in slave mode.
Sound Active Mode:
1.) To use this fixture in sound active mode, scroll to
SU--
using the
button, and hit . Then use the
buttons to scroll through its 31 built-in sound active chase patterns.
Select
SU01 - SU31
and hit .
Manual Color Adjustment:
Allows the user to adjust the color balance of the fixture. These settings are
global, they will effect all modes.
1.) Use the button to navigate to
Colr
and hit the
button.
2.) From here, you can navigate to
r255, 9255,
or
b255
and use the
buttons to adjust the global intensity of red, green, or
blue from
000 - 255.