Page 11 – Blizzard Lighting SnowBank (Rev B) User Manual

Page 11

Page 11

SnowBank User Manual Rev. B

Fixture Linking (Master/Slave Mode)

1. Connect the (male) 3 pin connector side of the

DMX cable to the output (female) 3 pin connector of

the first fixture.

2. Connect the end of the cable coming from

the first fixture which will have a (female) 3 pin

connector to the input connector of the next fixture

consisting of a (male) 3 pin connector. Then,

proceed to connect from the output as stated above

to the input of the following fixture and so on.

A quick note: Often,

the setup for Master-

Slave and Standalone

operation requires that

the first fixture in the

chain be initialized for

this purpose via either

settings in the control

panel or DIP-switches.

Secondarily, the fixtures

that follow may also

require a slave setting.

Check the “Operating Adjustments” section in this manual for

complete instructions for this type of setup and configuration.

Mounting & Rigging
This fixture may be mounted in any SAFE position provided there is

enough room for ventilation.

It is important never to obstruct the fan or vents pathway. Mount the

fixture using a suitable “C” or “O” type clamp. The clamp should be

rated to hold at least 10x the fixture’s weight to ensure structural

stability. Do not mount to surfaces with unknown strength, and ensure

properly “rated” rigging is used when mounting fixtures overhead.

Adjust the angle of the fixture by loosening both knobs and tilting the

fixture. After finding the desired position, retighten both knobs.

• When selecting installation location, take into consideration lamp

replacement access (if applicable) and routine maintenance.
• Safety cables MUST ALWAYS be used.
• Never mount in places where the fixture will be exposed to rain,

high humidity, extreme temperature changes or restricted ventilation.