Blizzard Lighting Nova (Rev. A) - Manual (Page 17)

Page 17
Nova™ Moving Head User Manual Rev. A © Copyright 2014 Blizzard Lighting, LLC
5. APPENDIX
A Quick Lesson On DMX
DMX covers (and is an abbreviation for) Digital MultipleXed signals. It is the most common
communications standard used by lighting and related stage equipment.
DMX provides up to 512 control “channels” per data link. Each of these channels was originally
intended to control lamp dimmer levels. You can think of it as 512 faders on a lighting console,
connected to 512 light bulbs. Each slider’s position is sent over the data link as an 8-bit number
having a value between 0 and 255. The value 0 corresponds to the light bulb being completely off
while 255 corresponds to the light bulb being fully on.
DMX data is transmitted at 250,000 bits per second using the RS-485 transmission standard over two
wires. As with microphone cables, a grounded cable shield is used to prevent interference with other
signals.
There are five pins on a DMX connector: a wire for ground (cable shield), two wires for “Primary”
communication which goes from a DMX source to a DMX receiver, and two wires for a “Secondary”
communication which goes from a DMX receiver back to a DMX source. Generally, the “Secondary”
channel is not used so data flows only from sources to receivers. Hence, most of us are most familiar
with DMX-512 as being employer over typical 3-pin “mic cables,” although this does not conform to
the defined standard.
DMX is connected using a daisy-chain configuration where the source connects to the input of the
first device, the output of the first device connects to the input of the next device, and so on. The
standard allows for up to 32 devices on a single DMX link.
Each receiving device typically has a means for setting the “starting channel number” that it will
respond to. For example, if two 6-channel fixtures are used, the first fixture might be set to start
at channel 1 so it would respond to DMX channels 1 through 6, and the next fixture would be set to
start at channel 7 so it would respond to channels 7 through 12.
Troubleshooting
Symptom Solution
Fixture Auto-
Shut Off
Check the fan in the fixture. If it is stopped or moving slower than
normal, the unit may have shut itself off due to high heat. This is to
protect the fixture from overheating. Clear the fan of obstructions,
or return the unit for service.
Beam is Dim Check optical system and clean excess dust/grime. Also ensure that
the 220V/110V switch is in the correct position, if applicable.
No Light Output Check to ensure fixture is operating under correct mode, IE sound
active/auto/DMX/Etc., if applicable. Contact service for more infor-
mation.
Chase Speed Too
Fast/Slow
Check to ensure proper setup of speed adjustment.
No Power Check fuse, AC cord and circuit for malfunction.
No Response to
Audio
Verify that the fixture is in “Sound Active” mode.
Adjust Audio Sensitivity, If Applicable.
Fixture Not
Responding /
Responding Er-
ratically
Make sure all connectors are seated properly and securely.
Use Only DMX Cables.
Install a Terminator.
Check all cables for defects.
Reset fixture(s).