beautypg.com

1 . getting started, Page 3, What’s in the box – Blizzard Lighting Motif Sketch (Rev A) User Manual

Page 3: Getting it out of the box, Powering up, Getting a hold of us

background image

Page 3

Motif Sketch™ Manual Rev. A

Copyright (c) 2012 Blizzard Lighting, LLC

1 . GETTING STARTED

What’s In The Box?

• 1 x Motif Sketch™ LED Fixture

• 1 x Mounting Bracket w/Bolts & Washers

• 1 x IP Rated AC Power Cord with Cable Cap

• 1 x Set of IP Rated DMX In/Out Cables

• This Lovely User Manual

Getting It Out Of The Box

Congratulations on purchasing one of the brightest, cutest little outdoor rated

fixtures anywhere! Now that you’ve got your Motif Sketch™ (or hopefully,

Sketch’s!), you should carefully unpack the box and check the contents to

ensure that all parts are present and in good condition. If anything looks as if

it has been damaged in transit, notify the shipper immediately and keep the

packing material for inspection. Again, please save the carton and all packing

materials. If a fixture must be returned to the factory, it is important that the

fixture be returned in the original factory box and packing.

Powering Up!

All fixtures must be powered directly off a switched circuit and cannot be run

off a rheostat (variable resistor) or dimmer circuit, even if the rheostat

or dimmer channel is used solely for a 0% to 100% switch.

AC Voltage Switch - Not all fixtures have a voltage select switch, so please

verify that the fixture you receive is suitable for your local power supply. See

the label on the fixture or refer to the fixture’s specifications chart for more

information. A fixture’s listed current rating is its average current draw under

normal conditions. Check the fixture or device carefully to make sure that if a

voltage selection switch exists that it is set to the correct line voltage you will

use.

Warning! Verify that the voltage select switch on your unit matches the

line voltage applied. Damage to your fixture may result if the line volt-

age applied does not match the voltage indicated on the voltage selec-

tor switch. All fixtures must be connected to circuits with a suitable

Ground (Earthing).

Getting A Hold Of Us

If something is wrong, just give us a call or send an email. We’ll be

happy to help, honest.

Blizzard Lighting

W220 N1531 Jericho Ct. Suite E, Waukesha, WI 53186 USA

[email protected]

www.blizzardlighting.com

866-493-6025