Blizzard Lighting 300 HushPar Infiniwhite - Manual (Page 12)

Page 12
HushPAR InfiniWhite 300 Manual Rev. A Copyright © 2013 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the fixture is DMX, which appears as
Addr
on the LED readout. To
select a different DMX address, hit the button and use the buttons
to select the correct address, then hit to confirm.
Master/Slave, Sound Active, Auto Modes:
Allows a single or Master/Slaved units to run factory installed programs at user selectable speeds.
Master/Slave Mode:
1.) To use your HushPAR Infiniwhite™ 300 fixtures in Master/Slave mode: use standard DMX
cables to daisy chain your units together via the DMX in/out connectors on the rear of the
units. The first fixture after the controller in the chain is the master. Any fixture thereafter will
automatically be set to slave, and wil function as the master unit does.
Sound Active Modes:
1.) To use Sound Active Mode 1 (color flash), use the buttons to select
SoUF ,
then press the button to confirm.
2.) To use Sound Active Mode 2 (color jump), use the buttons to select
SoUA
then press the button to confirm.
Built-in Programs:
1.) There are 16 built-in programs. Use the buttons to select
Pr--, then press
the button. Then use the buttons again to choose Pr00-Pr15 , then
press the button. Pr00-Pr06 are 7 built-in static colors, Pr07-Pr13 are 7 built-in
strobe colors, Pr14 is 3-color jump, and Pr15 is 7-color jump.
2.) To adjust the speed of the built-in programs, use the buttons to select SP--,
then press the button. Then use the buttons to select SP00-SP15
(fast <-> slow).
Auto Mode:
1.) To use the fixture in Auto Mode, use the buttons to select
ASC- , then press
the button. Then use the buttons to select AS00-AS15 (fast <->
slow).
Flash (Strobe) Mode:
1.) To use the fixture in Flash Mode, use the buttons to select
FLAS , then press
the button. Then use the buttons to select FL00-FL15 (fast <->
slow).
Fade Mode:
1.) To use the fixture in Fade Mode, use the buttons to select
FAdE , then press
the button. Then use the buttons to select FA00-FA15 (fast <->
slow).
Manual Color Adjustment:
Allows the user to adjust the color balance of the fixture.
1.) Use the buttons to scroll to either
rL
(amber),
gL
(cool white), or
bL
(warm white), and press . Select the maximum level for each color between
0-255
(0=off), then hit to confirm.