Setup, Id code, Page 15 – Blizzard Lighting Blade RGBW (Rev A) User Manual

Page 15

Page 15

Blade™ RGBW User Manual Rev. A

Setup Mode

ID Address

ID Address mode allows you to utilize up to 850 fixtures on only 1 DMX universe
while maintaining full individual control over each fixture. You can assign ID
addresses to your fixtures within the

SetUp

menu settings.

Navigate to the

SetUp

icon on the LCD display using the buttons

and press . Then use buttons to highlight

Id Code

and

press the button. Then scroll to the fixture ID address number that
you’d like to assign to the fixture using the buttons, and push the
button to confirm your choice.

Pan Reverse, Tilt Reverse, and Fader Delay

Reverse the settings of Pan and Tilt within this menu selection. Use the DOWN> buttons to scroll to

SetUp

and hit the button. Push the

button again while either of these are highlighted. Then use the DOWN> buttons to highlight

Off.

Then push the button to

confirm your choice.

Here you can also turn On/Off the Fader Delay in the same manner (bet your
getting pretty good by now!)

1.) OFF – Fixture dimming curve is 256 steps, linear
2.)

ON – When in 15-channel mode, and with channel 12 set between DMX values

(001-025), the fixture will slow and smooth the dimming curve by adding addi-
tional dimming steps. This is particularly noticeable during long or slow dim/fade
times.

Signal Link

1.)

OFF – Fixture will continue last known function if there is a DMX signal loss

2.)

ON – Fixture will turn off if there is a DMX signal loss

Code Wheel (Position Correction)

1.)

OFF – Fixture will not automatically attempt to auto-correct positioning

2.)

ON – Fixture will automatically attempt to auto-correct positioning

Screen Saver

1.)

OFF – No screen saver

2.)

Mode1 – Large, current DMX channel display as screen saver

2.)

Mode2 – Display will shut off