Blizzard Lighting Blade RGBW (Rev A) - Manual (Page 14)

Page 14
Blade™ RGBW User Manual Rev. A Copyright (c) 2012 Blizzard Lighting, LLC
Address - DMX Channel Selection
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the fixture is DMX, which appears as 001 on the LCD Read-
out. To select a different DMX address, use the buttons to highlight
the
Address icon and push . Then use the use the
buttons to choose your desired starting DMX address, then hit again to
confirm your choice.
2.) Note: This fixture does not require additional settings to run as a slave.
The first fixture linked in the DMX chain will serve as the master.
Run Mode - DMX Mode, Auto, & Sound Active:
Allows a single or Master/Slaved units to run factory installed programs at user selectable
speeds.
1.) To use the fixture in 11 or 15 channel mode, use the buttons to
scroll to
RunMode and hit the button. Push the button again
while DMX is highlighted and scroll to either 11Ch or 15Ch. Then push the
TER> button to confirm your choice.
2.) To set the fixture in automatic mode, use the buttons to scroll to
RunMode and hit the button. Push the button again while
Auto is highlighted and choose from Auto1 to Auto8. Then push the
button to confirm your choice.
3.) To set the fixture in sound active mode, use the buttons to
scroll to
RunMode and hit the button. Push the button
again while Sound is highlighted. Then push the button to confirm your
choice.
Test Mode
A special mode which allows you test the fixtures x-axis motor, y-axis motor, and
focus motor position (000-255). Here you can also test red, green, blue, and white
intensity (000-255). These RGBW settings also serve as the user defined
color in 15-channel DMX mode, channel 10.
Language
This is where you can change the language settings of the fixture from English to
Chinese, if so desired. Hint: You might wanna start learning it sooner, rather than
later!