Bendix Commercial Vehicle Systems EC-60 ESP Controllers (Advanced Models) - Manual (Page 26)

26
Location Measurement
TCV to TCV Common 7 to 19 Ohms
Release, Hold, Common Open Circuit (no continuity)
to Voltage or Ground
Troubleshooting Diagnostic Trouble Codes:
Traction Control Valves
18 Drive Axle Traction Control Valve
19 Steer Axle Traction Control Valve
1st. Blink
Code
Location
2nd. Diagnostic
Blink Trouble Code
Code Description
1 TCV Solenoid
Shorted to
Ground
2 TCV Solenoid
Shorted to
Voltage
3 TCV Solenoid
Open Circuit
4 TCV
Configuration
Error
Verify 7 to 19 ohms between TCV and TCV common. Verify no continuity between
TCV leads and ground. Check for corroded/damaged wiring or connectors between
ECU and TCV.
Verify 7 to 19 ohms between TCV and TCV common. Verify no continuity between
TCV leads and voltage. Check for corroded/damaged wiring or connectors between
ECU and TCV.
Verify 7 to 19 ohms between TCV and TCV common. Check for corroded/damaged
wiring or connectors between ECU and TCV.
The ECU is not configured for ESP or ATC, but has detected the presence of a TCV.
Verify TCV wiring. Inspect for the presence of a TCV. Verify ECU configuration.
Repair Information
Cab-mount ECU:
Looking into wire harness connector
Traction Control Valve Repair Tests:
1. Take all measurements at ECU harness connector pins in order to check wire harness
and traction control valve. Probe the connector carefully so that the terminals are not
damaged.
Connector Pin Traction Control Test
X1 4 Drive Axle Traction Control Valve Common
18 Way 5 Drive Axle Traction Control Valve
Connector Pin Traction Control Test
X3 3 Steer Axle Traction Control Valve Common
15 Way 5 Steer Axle Traction Control Valve
X 4