Behringer Firebird GX108 - Manual (Page 5)

5
2. INSTALLATION
8 FUSE HOLDER / VOLTAGE SELECTOR. Please make sure that your
local voltage matches the voltage indicated on the unit, before you attempt
to connect and operate the GX108. Blown fuses may only be replaced by
fuses of the same type and rating. Some models allow for inserting the
fuse holder in two different positions, in order to switch over from 230-V to
115-V operation, and vice versa. Please note that for 115-V operation
outside Europe, you need to use a fuse of a higher rating (see chapter 1.1).
9 Use the enclosed power cord to connect the unit to the mains.
10 The stereo 1/4" PHONES jack allows you to monitor the GX108’s audio
signal with a pair of commercially available headphones. Connecting the
headphones will mute the built-in speaker.
11 The TAPE OUT cinch connector supplies the audio signal of your GX108,
for example to send it to a recording machine.
12 The TAPE IN cinch connector allows you to connect an external signal
source such as a drum computer or other machine providing audio
playbacks.
13 SERIAL NUMBER. Please take the time to have the warranty card filled
out completely, and return it within 14 days after the date of purchase, so
as to be entitled to benefit from our extended warranty. Or use our online
registration option available on the World Wide Web at www.behringer.com.
2. INSTALLATION
2.1 Mains connection
The mains connection is made by using the enclosed power cord and a standard
IEC receptacle. It meets all of the international safety certification requirements.
2.2 Audio connections
The input of your FIREBIRD GX108 is on a mono 1/4" jack, the PHONES output
on a stereo 1/4" jack. The tape inputs/outputs are on cinch connectors.
+
Please ensure that only qualified personnel install and operate the
GX108. During installation and operation the user must have sufficient
electrical contact to earth. Electrostatic charges might affect the
operation of the FIREBIRD GX108.