Bendix Commercial Vehicle Systems BA-922 COMP - Manual (Page 8)

Bendix
®
BA-922
®
Compressor Installation and Application Review
Page 8 of 14
BW2514 ©2006 Bendix Commercial Vehicle Systems LLC • All Rights Reserved • 3/22/06 • rev: 1.
Discharge
line
First component after compressor (filters, separators, traps, dryers)
What:
_________________________________________
Line ID size to: ____________________________________
Distance to: ____________________________________
Second
component after compressor (filters, separators, traps, dryers)
What: _________________________________________
Line ID size to: ____________________________________
Distance to: ____________________________________
Third component after compressor (filters, separators, traps, dryers)
What: _________________________________________
Line ID size to: ____________________________________
Distance to: ____________________________________
Is the discharge piping routed in a downhill manner to the air dryer?
YES NO
Measured compressor discharge pressure
(measured at the compressor) ______________________
Recommended
Test Procedure:
Install a pressure gauge at the discharge fitting of the compressor and record the
discharge pressure at the time of governor cut-out.
Note, any devices in the discharge line between the compressor and air dryer should
represent their maximum possible restriction when the discharge pressure of the
compressor is being measured.
Was measured discharge pressure greater than 150 psi? YES NO