Bendix Commercial Vehicle Systems SB-7 AIR DISC BRAKE - Manual (Page 26)

26
M+P-KN-022
B
13
M+P-KN-023
B
13
M+P-KN-021
B
13
Using Tool B in reverse direction, the Tappet can be
pressed on.
With Caliper not installed on axle
Grease threads with RENOLIT HLT2 (Order No.
II14525).
Screw back Threaded Tubes (16), by turning the
Adjuster (23) counter-clockwise.
Sealing seat in the caliper for Tappet with Boot (13)
must be clean and free of grease.
Place new Tappet Bushing (161) onto the head of the
Tube (16).
Place Tappet with Boot (13) onto the head of the
Tube.
Use Push-In Tool with the long strut (B) (Order No
II19252) for positioning and pressing-in the Boot (13).
Using the Tool (B) in reverse direction, the Tappet can
be pressed on.