Baumfolder Rebuilding a small, older folder - Manual (Page 7)

Section 1 - How to Rebuild a Baumfolder..... continued
11.
Install the gears and belts on the non-operator side of the folder.
12.
Replace the register table in reverse order that it was removed.
13.
Replace ALL guards. Replace the slitter shaft. If you rebushed the slitter shaft boxings,
put the right and left boxing in place and line ream from left to right then right to left.
then install the slitter shafts, gears, and collars. If you have to line ream the slitter
boxings, do it BEFORE installing the guard.
14.
Replace the hand wheel with a new free wheeling hand wheel.
15.
Turn the folder over by hand several times to be sure nothing binds or rubs.
16.
Square the side guide on the register with the number one roll.
17.
Set all fold rolls, see section on calibrating baumsets and setting rollers.
18.
Again turn folder over by hand and if every thing is free, apply power supply, turn folder
on and off to verify there is no electrical or mechanic problems and if not, run the folder
slow for a few minutes. Turn off the folder to see if there are any hot spots, Make SURE
power is turned off. If every thing is free, set up the folder and check for folder
accuracy.
NOTE:
These instructions use the dimension 5 ° and .718 for some models of Baumfolders.
Other models use different dimensions – See the following section “Baumfolder and
O&M Gauges” for the proper dimensions for your folder.
Section 1 - Page 7