Baumfolder 714XLT: Air-Operations Manual (from 2001 thru 2005) - Manual (Page 5)

PAGE 5 TP10289-2
Figure 4.1-1
Pump
Plug/Cord Set
4.2 Pump Electrical Connections
The pump has a plug/cord set attached. This plug
fits directly into the rear of the lefthand side cover. (See
Figure 4.2-1)
WARNING
Do not plug the power cord into an AC outlet until
the 714XLT Air Feed is fully assembled, adjusted and
ready to use. Unplug the 714XLT any time disassembly is
required.
4.0 ASSEMBLY
4.1 Main Unit
To assemble the 714XLT Air Feed unit, first remove
the four bolts holding it to the skid. Place the folder on the
stand (See Figure 4.1-1).
4.3 Pump Hose Connections
Two hoses come with your 714XLT Air
Feed. (See Figure 4.3-1)
Air
Vacuum
For
Pump
Hoses
Figure
4.3-1
4.4 Slitter Shaft Installation
To install the slitter shaft, hold it with the grooves in
the boxings down. Be sure the slitter shafts are free
turning.
Insert the slitter shaft and seat the grooves in the
boxings on the lower locating pins in the side frames. (See
Figure 4.4-1)
Check for proper gear engagement between the upper
slitter shaft gear and the 19-tooth frame idler gear by
turning the handwheel.
Slitter Shaft Assembly
Figure 4.2-1