Baumfolder ND5 Drill (from 2000 thru 2002) - Manual (Page 4)

TP10354 4
ND-5 PAPER DRILL
Your new ND-5 Paper Drill has been designed to provide you
with years of useful service, provided it is installed, main-
tained and operated according to the instructions contained
in this manual.
The ND-5 Paper Drill has the capability for five drill heads,
and is available with either a stationary (ST) or moveable
(MT) table. Dill bits are available in sizes ranging from 1/8”
to 1/2” in diameter.
SAFETY INSTRUCTIONS
All guards, warning labels, lubrication and caution tags were
placed on this machine for your safety. Take time to become
familiar with all of them. These items must not be removed
from this machine.
The operation and maintenance of this machine should be
clearly understood. Besides exercising standard safety prac-
tices, operators, maintenance personnel and any other per-
sonnel involved with this drill, should be specifically instructed
on proper maintenance and safe operation of this machine.
All safety mechanisms are provided for your protection and
must not be altered.
WARNING
Do not operate this machine without all
guards in place.
Do not make any adjustments or perform any main-
tenance on this machine with power on.
Keep the machine and the work area clean and free
of spills, to prevent accidents.
Be certain to replace any safety decals that may
have been detached for any reason.
INSTALLATION INSTRUCTIONS
This machine is shipped inside a protective wood frame. The
following parts are packaged inside the machine at the factory:
Waste Can Wood Blocks
Back gage Bar Drill Sharpener
Back gage Blocks Side Gage
Tools Instruction Manual
Carefully remove the wood frame and remove one of the side
covers to find these items. Be sure to check off the parts re-
ceived against the packing list. Examine the machine carefully
for any physical signs of shipping damage.
The machine is fastened to the skid with four bolts. Remove
these bolts and then carefully position the machine on the, floor.
Level the machine to prevent rocking during operation.
BACK GAGE INSTALLATION
Place the back gage bar at the rear of the table top. Insert the two
clamp knobs through the clearance holes provided in the bar.
Screw the clamps onto the bottom of the threaded rod that ex-
tends from the clamp knobs. Place the two back gage blocks on
the bar so that the thumbscrews are pointing toward the rear of
the machine. Set the bar using the scales on the right and left
sides of the table.
SIDE GAGE INSTALLATION
Slide the side gage assembly into the T-slot provided in the
table top. Slide the side gage to a location desired on the table
scale and tighten the knob by hand.
WASTE CAN INSTALLATION
Hang the waste can on the two shoulder screws at the top of the
rear of the machine base.
T00LS
A convenient accessories drawer has been provided on the
rear right hand corner of the machine base. A removable tray
is furnished for storing drill bits in a bath of lubricant while
they are not in use. All other tools can be placed in the other
compartment for quick, convenient access.
HYDRAULIC SYSTEM
Checking the hydraulic oil level in the reservoir is done by re-
moving the right hand side cover and removing the four screws
that fasten the lid to the reservoir. The return line hose may
remain connected. The oil level must be just below the port
located near the top on the side of the reservoir. Do not fill
above this port!