Baumfolder BAUM15: Pile Folder 1st Station (from 2005 on) - Manual (Page 19)

PAGE 19 TP10290-2
2.7 Production Mode
Enter Run Mode and Select Large Display Content
These keys do not operate as mode select keys in
counter setup. In all other modes, the keys both select the
large display (1) contents and place the counter into run
mode. Pushing one of the buttons will light the button’s
associated LED and cause the parameter to be displayed. If
both the input and output count keys are pressed simulta-
neously, then both LEDs go on and the waste count is
displayed. See Process Variable Definitions.
Table 12. Determining the Large Display Contents
When the folder is started the counter will start up in
the run mode, the normal operating mode of the counter.
In this mode, various job parameters can be displayed on
the large display (1) and the small display (2) shows the
gap length. The suction length display (3) is active in this
mode and shows the suction length as a percentage of sheet
length.
Gap Length Adjustment
The gap length adjustment keys allow the user to
change the current gap length. The range of adjustment is
0.2” to 98.0” (0.5 cm to 250 cm).
Suction Length Adjustment
The suction length adjustment keys allow the user to
change the amount of suction applied to the current sheet
length. The display shows the percentage in 5% steps. All
of the bars must be totaled to get the value. The range of
adjustment is 5% to 50% of the current sheet length.
h
h
h
h
h
h
Output Count
Batch Count Down
Number of Batches
Current Rate
Input Count
Waste Count
Large Display Contents
h
+
+
h
0
This mode is only available if a STA-NET adapter is
installed and activated through maintenance mode. In this
mode the small display (2) always shows the word ‘Job’.
The large display (1) shows either ‘PAuSE’ or a job
number which can be read from the network. The suction
length display is disabled.
Select Job Number
This set of plus and minus keys step the large display
(1) through pause mode and a list of available job numbers.
While in network job mode, the folder is considered to be
paused.
Load Job and Return to Run Mode
When this button is pushed the selected job will be
loaded into the counter and the counter will return to run
mode. If the large display (1) was showing the message
‘PauSE’, the network job mode will end, but no job will be
loaded.
Exit Network Job Mode
Pressing any of these keys will cause the counter to
change to a new mode.
+ +
+ +
h
Exit Make Ready Mode
Pressing any of these keys will cause the controller to
change to a new mode.
2.6 Network Job Mode
Pushing this key puts the counter in network job mode