Beko D 6082 B - Manual (Page 7)

7
• This product is designed for home use.
• Your washing machine is adjusted to 220V.
• If the fuse in your house is less than 16A than have a
certified electrician deploy an 16A fuse.
• In case of transformer or non-transformer use,
grounding installation must be performed with a
licensed electrician. Any use before grounding is not
our responsibility.
• Never place your machine over a carpet covered
floor. Otherwise electrical parts of your machine may
overheat. This may cause malfunction of your machine.
• Make sure hot and cold taps are connected correctly.
Otherwise your laundry may come out hot and torn .
• Please call certified service for a failure of electric plug/
cable.
• Be careful about your water hoses are not old. Do not
use old/torn water hoses. This may cause stain in your
laundry .
• At first use, washing must be performed at Cotton 90°C
program without loading with laundry for getting your
machine ready for washing.
• Performance of your washing machine depends on
the quality of water and hygiene compound used. If
low quality and unfitting cleaning material is used the
stains will be fixed. Before washing your laundry with
stain keep your attention on cleaning the laundry as
explained in following pages.
•
Lifetime of your product is 10 years.
This is period of keeping spare parts for your machine
to operate.
• Because of quality control procedures there might be little
amount of water in your machine.
This does not have any damage to your machine.
• Your machine is programmed for starting operation
again when electricity is off and on afterwards. You can
not press On/Off button to cancel program. Machine
will go on program when electricity is on. To CANCEL
the program press >Start/Pause/Cancel< button for
three seconds. (See. Canceling a program)
• If pre-wash additional function led is blinking than your
machine is in child-proof-lock position. (See. child-
proof-lock)
If “Ready” led on program progress display is blinking
program selection knob is middle position. In this
case turn the knob and adjust it again. If the warning
continues call authorized service.
• After your machine starts operation if Start/Pause/
Cancel key starts blinking than door is not locked.
Open and close the door again begin washing program
2 Warning