Beko D 6082 B - Manual (Page 20)

20
Installation
If your system is not ready, let a certified plumber make it
ready.
1. Removing the transportation locks
Before the washing machine is operated, the transit bars
must be removed! In order to do this:
1. Loosen “C” bolts by rotating them counter clockwise with
a suitable spanner
2. Remove transportation locks by turning.
3. Place “P” plastic covers onto the openings of transporta-
tion locks by rotating in direction of arrow and pushing.
Attention please! Store the transit bars for using when
machine is to be transported again. Always transport your
machine with transportation locks.
2. Leveling the feet
Or order to operate your machine without noise and
vibration it must be properly on balance. Four feet of your
machine can be adjusted. First loosen plastic counter bolt.
Tighten the counter bolt after adjusting the feet for leveling
your machine.
3. Water Connections
a) Water Inlet Hose
Your machine is connected to water supply by special
hoses supplied by the machine. Red hose or hose written
red on it is hot water inlet, blue hose or hose written blue
on it is cold water inlet.
There plastic seal (4 for double water inlet models, 2
for single water inlet models) on hose or plastic bag for
eliminating any leakage in connections points. These seals
must be used on each side of the connection. Seals on
machine side must be connected filter cannal.
6