Brother DsMobile 600 - Manual (Page 13)

- 9 -
INSTALLING HARDWARE
Do not connect the scanner to your computer until instructed to do so by the driver installation
software. When instructed to do so, connect the scanner cable as shown below and follow the
instructions.
After you have installed the software (Steps 1-4, p. 2-4), Step 5 will instruct you to install your
scanner. You may also follow the steps below if the software has already been installed.
Otherwise, proceed to Calibration.
1. Connect the USB cable to the scanner and to a USB port on your computer as shown
below (either to a desktop or laptop computer). If necessary, please check your
computer’s user guide to identify the USB ports available and their locations.
2. The computer will automatically detect a new hardware device and MAY, during the
initial installation, advise you to follow the Hardware Wizard installation (see below).
If the Hardware Installation Wizard screen is not displayed, go to Step 4.