Bang & Olufsen BeoSound 2 - User Guide - Manual (Page 12)

12
>> English
Maintenance, etc.
Recharge battery
When the built-in battery requires recharging, a beep, repeated every 30
seconds, sounds from BeoSound 2. You can silence this signal by pressing
GO
on the keypad once.
Place BeoSound 2 on the docking station. Recharging begins. You can leave
BeoSound 2 on the docking station without risk of overcharging the battery.
An 80% battery charge is reached after approximately one and a half hours,
and a full charge is reached after approximately two and a half hours. Starting
from a fully-charged state, the battery in BeoSound 2 will provide
approximately 8 hours of use.
Reset BeoSound 2
If BeoSound 2 doesn’t respond, you can reset it. Press and hold and .
Then press
GO for two seconds. This resets BeoSound 2. No data is lost.
Update BeoSound 2 Firmware
Updates for BeoSound 2 will be available for download via
www.bang-olufsen.com. Go to the previous pages for instructions.
Cleaning BeoSound 2
Wipe dust off the surfaces using a dry, soft cloth. Remove grease stains or dirt
with a lint-free, firmly wrung cloth, dipped in a solution of water containing
only a few drops of mild detergent, such as washing-up liquid.
Memory card
To ensure a long lifetime, memory cards must be handled with care. Always
keep the card inside the BeoSound 2, or in the cartridge supplied with the
card. Please note that formatting will not be possible if you have write-
protected the card (formatting will erase all content on the card).
MultiMedia (MMC) and Secure Digital
(SD) cards are available from a number
of suppliers. Memory cards from
SanDisk has been tested and approved
for use in BeoSound 2. You can write-
protect an SD-card by moving the
slider down.