Bang & Olufsen BeoSound 2 - User Guide - Manual (Page 11)

11
Switch between playback and download: BeoSound 2 must be placed on
the docking station. Press
GO to start playback, or press and hold GO for 2
seconds to connect to the computer – enabling you to download to
BeoSound 2. The docking station light changes colour accordingly.
Change mode: Switch between BeoPlayer and iTunes mode. BeoSound 2 is
in BeoPlayer mode per default. To change this setting, make sure that
BeoSound 2 is paused, and that the Earphones are connected.
BeoSound 2 feedback
Audible feedback: BeoSound 2 gives you audible feedback for example
when:
– Battery power is low (beep repeated every 30 seconds)
– Error occurs (beep repeated every 5 seconds)
– Firmware update is completed
– A memory card is formatted
Docking station light feedback: When BeoSound 2 is placed on the
docking station, the docking station lights up to indicate its current status:
Green… Track playback or pause, not connected to the computer.
Red… Download mode, connected to the computer.
Orange… Resetting – continuous orange light feedback indicates error.
Flashing light (red or green)… Battery charging.
Flashing red and green, followed by orange, then red… Updating Firmware.
Go to iTunes mode:
Press and hold and .
Then press
GO twice, without
letting go of the first two buttons.
Audible feedback informs you that
BeoSound 2 has changed to iTunes
mode.
Go to BeoPlayer mode:
Press and hold and .
Then press
GO twice, without
letting go of the first two buttons.
Audible feedback informs you that
BeoSound 2 has changed to
BeoPlayer mode.