Bang & Olufsen BeoLab 9 - User Guide - Manual (Page 5)

Set up the loudspeakers
We recommend that you follow
this procedure when you set up
the loud speakers:
– Disconnect your system from the
mains supply.
– Connect your loud speakers and set
the switch marked LINE–RIGHT–LEFT
on each loud speaker as explained in
‘Cable connections’ (pp. 6–7).
– Set the switch marked FREE–WALL–
CORNER to the correct setting on
each loud speaker. This is explained
in ‘Adapt the loud speakers to your
room’ (pp. 8–9).
– Connect your entire system to the
mains supply again.
Cautions
– Make sure that the loud speakers are placed
and connected in accordance with the
instructions in this Guide. To prevent injury,
use Bang & Olufsen approved stands and
wall brackets only!
– The loudspeakers can only be switched off
completely by disconnecting them from the
mains supply. Therefore, connect the loud-
speakers to an easily accessible wall socket.
– Do not attempt to open the loud speakers.
Leave such operations to qualified service
personnel!
– The loud speakers are designed for in door use
in dry, domestic environments only, and for
use within a temperature range of 10–40º C
(50–105º F).
– For optimum sound quality, do not place the
loud speakers enclosed in a small space, and
never place anything directly in front of the
loud speakers.
– Place the loudspeakers with the front facing
your favourite listening position.
5
The loud speakers must be placed standing
upright on the base on a firm and level surface.