Bang & Olufsen BeoLab 7-2 - User Guide - Manual (Page 3)

Daily use
When you have finished setting
up the loudspeaker as described
on the following pages, connect
the entire system to the mains.
Loudspeaker protection
The loudspeaker is equipped with a
thermal protection system which
prevents damage from overheating.
If an error occurs – or the speaker
units become overheated – the
system automatically switches the
loudspeaker to standby.
To restore the sound:
> Disconnect the loudspeaker from
the mains.
> Allow the system time to reset or
cool down (approximately 3–5
minutes).
> Reconnect the loudspeaker to the
mains.
Should the problem persist, contact
your Bang & Olufsen retailer.
Cleaning the loudspeaker
Clean dusty surfaces using a dry,
soft cloth. If necessary, remove
grease stains or persistent dirt with
a lint-free, firmly wrung cloth,
dipped in a solution of water
containing only a few drops of
mild detergent, such as washing-
up liquid.
The loudspeaker front grill may be
cleaned with a vacuum cleaner with
a soft brush nozzle, and set to the
lowest level.
Never use alcohol or other solvents to
clean any parts of the loudspeaker!
Switching on and off
When you switch on your Bang &
Olufsen system, the loudspeaker
switches on simultaneously, and
when you switch the system off
again the loudspeaker also switches
off.
Caution: Handle the loudspeaker
front grill with great care. Dents
and scratches are not covered by
the guarantee!
3