Balboa Water Group Dolphin II - Manual (Page 20)

20
PROGRAMMING CD
CONTROL
Locate the brand name of your CD Player in the
Setup Codes For CD Players section below, and
write it in the following space.
CD Player Brand:
The brands are listed in alphabetical order with
the most popular codes listed first. You will use
one of these codes to program the Dolphin to
operate your CD Player:
1. Turn on the CD Player.
2. On the Dolphin, press CD once. Press and
hold SETUP until the LED blinks twice, then
release SETUP.
3. Enter the first four-digit code for your CD
Player. If you perform this procedure correctly,
the LED will blink twice.
NOTE: If the LED did not blink twice after entering
the code’s last digit, repeat steps 2 through 3 and
try entering the same code again.
4. Aim the Dolphin at your CD Player and press
POWER once. The CD Player should turn off.
If it does not respond, repeat steps 2-4,
trying each code for your brand until you find
one that works. If it still does not work, try
searching for the code (see Searching For Your
Code on page 25).
5. Write your CD code in the boxes below for
future reference.
QQQQ
NOTE: Remember, to use the Dolphin to operate
your CD Player, press CD first.
Setup Codes for CD Players:
Aiwa 0157
Burmester 0420
California Audio Labs 0029, 0303
Carver
0157, 0179, 0437
CCE 0157
Classic 1297
Denon 0003, 0873
DKK 0000
DMX Electronics 0157
Emerson 0305
Fisher 0179, 1325
Garrard 0420, 0393
Genexxa 0032, 0305
GPX 1296
Harman/Kardon 0157, 0173, 1202
Hitachi 0032
Integra 0101
JVC 0072, 1294
Kenwood 0826, 0626, 0028, 0037, 0190, 0681
KHL 1711