Balboa Water Group Dolphin II - Manual (Page 12)

12
PROGRAMMING
VCR CONTROL
Locate the brand name of your VCR in the Setup
Codes For VCRs section below, and write it in the
following space.
VCR Brand:
The brands are listed in alphabetical order with
the most popular codes listed first. You will use
one of these codes to program the Dolphin to
operate your VCR:
1. Turn on your VCR and insert a video cassette.
2. On the Dolphin, press VCR once. Press and
hold SETUP until the LED blinks twice, then
release SETUP.
3. Enter the first four-digit code for your VCR. If
you perform this procedure correctly, the LED
will blink twice.
NOTE: If the LED did not blink twice after entering
the code’s last digit, repeat steps 2 through 3 and
try entering the same code again.
4. Aim the Dolphin at your VCR and press POWER
once. The VCR should turn off. If your VCR
remote control does not have a POWER key,
press PLAY. If the VCR does not respond, repeat
steps 2-4, trying each code listed for your
brand until you find one that works. If the VCR
still does not work, try searching for the code
(see Searching For Your Code on page 25).
5. Write your VCR code in the boxes below for
future reference.
QQQQ
NOTE: Remember to use the Dolphin to operate
your VCR, press VCR first.
Setup Codes for VCRs:
ABS 1972
Admiral 0048, 0209
Adventura 0000
Aiwa 0124, 0000, 0037
Akai 0175
Alienware 1972
American High 0035
Asha 0240
Audiovox 0037
Beaumark 0240