AJA FS2 Quick Start - Manual (Page 3)

1
3 FS2 Quick Start Guide — Display Menu Summary
3. You can skip this step if you are using DHCP. If you selected Static Addr in step 1,
turn the
SELECT knob to display menu 2.3 Subnet Mask. Change this to match the
Subnet Mask setting in your computer's Network panel/preferences, using the same
procedure described above in step 2 to change the static address.
4. You can skip this step if you are using DHCP. If you selected Static Addr in step 1,
turn the
SELECT knob to display menu 2.4 Default Gateway. Change this to match the
Gateway Address setting in your computer's Network panel/preferences, using the
same procedure described above in step 2 to change the static address.
5. Open a web browser on the computer connected to the FS2 and enter the FS2 IP
address in the browser's address field. When the browser connects, the FS2 Status
menu screen appears (shown in “Web Browser Menu Summary” on page 4).
6. Configure video and audio I/O as explained in Quick Workflows, “Video and Audio
Right Out of the Box” on page 6, and test the FS2.
If the FS2 is working, configure it for your environment using the menu system. The
following pages summarize the menus, and the FS2 Installation and Operation Guide
on the supplied DVD describes the menus in detail. You can also contact AJA
Technical Support for assistance; please see the contact information at aja.com.
Display Menu Summary
The following illustration and table summarize front panel display operation.
P a r a m n u m b e r & n a m e
C u r r e n t S e t t i n g
M e n u g r o u p & s t a t u s
I n f o o r P r o m p t
Turn the Select knob to scroll
through parameter menus.
Push Select to undo changes.
SELECT ADJUST
14.1 Output Timing H
0
SDI 1 1080i59.94
Use buttons to select
a Menu Group
Status Config System Video 1 Video 2
Remote Preset Output Audio1 Audio 2
Parameter Menu
Current Setting
Menu Group & Status
Info or Prompts
Turn Adjust to
change current setting.
Hold down Adjust to
restore default value.
Menu Group Purpose Parameter Descriptions
STATUS Status and Error Conditions • Status of Video 1, Video 2, Caption, Reference, GenLock,
Power, Temperature , and Alarms
REMOTE FS2 Control Method • Local front panel, Remote, or Local and Remote Control
• GPI Input and Output behavior
CONFIG FS2 Configuration • IP and SNMP settings, MAC address
• Alarm Control
• Hidden Menu Access and Display Intensity (brightness)
• System Name
• System Serial Number and Software Version
• System Reboot