Braun NL Series - Manual (Page 49)

Page 47
Maintenance and Lubrication Schedule
Resecure, replace or correct as needed
Use Braun 32840-QT (Exxon ® Univis HVI 26)
K\GUDXOLFÁXLGdo not mix with Dextron III or other
K\GUDXOLFÁXLGV&KHFNÁXLGOHYHOZLWKplatform
lowered fully and roll stop unfolded fully. Fill
WRZLWKLQßRIWKHERWWRPRIWKHßÀOOWXEH
(neck).
Tighten, repair or replace if needed.
Tighten, repair or replace if needed.
Inspect cotter pins on platform pivot pin (2)
Hydraulic Fluid (Pump) - Check level. Note: Fluid
should be changed if there is visible contamination.
,QVSHFWWKHK\GUDXOLFV\VWHPF\OLQGHUKRVHVÀW-
WLQJVVHDOVHWFIRUOHDNVLIÁXLGOHYHOLVORZ
,QVSHFWF\OLQGHUVÀWWLQJVDQGK\GUDXOLFFRQQHFWLRQV
for wear, damage or leaks
Inspect outer barrier cylinder hose assembly (hose,
fasteners, connections, etc.) for wear, damage or
leakage (if equipped)
4500
Cycles
Perform all procedures listed in previous sections also
1500
Cycles
Resecure, replace or correct as needed. Remove pump module cover and inspect:
‡+\GUDXOLFKRVHVÀWWLQJVDQGFRQQHFWLRQVIRU
wear or leaks
• Harness cables, wires, terminals and connec-
tions for securement or damage
• Control board, circuit breaker, power switch and
lights for securement or damage
continued