2 attach camera – 3D Robotics Tarot gimbal User Manual
Page 2
2 Attach camera
Your Tarot gimbal is compatible with a GoPro HERO3, available from
.
Remove the two screws securing the blue face plate.
Remove the plate, and loosen the set screw.
1
face plate
remove
Slide camera into housing with the lens nearest
the top-right corner.
2
assembled leg
Add the nut to the bolt, and tighten to secure the leg to the arm.
Attach all four tall legs to IRIS.
3
Optional: To remove the short legs, use
the small hex key (1.5 mm) to remove the
screw in the bottom of the leg, and slide
the leg out of the arm.
!
Important note: Make sure that the WiFi on your GoPro is
turned OFF at all times when in use with IRIS.
remove
loosen